On Mon, Jun 07, 2004 at 03:29:55PM +0530, Vikrant Agarwal wrote:
> Hi All,
>
> I've installed rrdtool-1.0.48 under /usr/local/rrdtool-1.0.48/ directory after that I've installed snips . After installation and configuration when I'm trying to run ippingmon monitor it gives me following error .
The install/compilation tends to depend on it in /usr/local/rrdtool
(which can just be a symlink to /usr/local/rrdtool-1.0.48). From the
errors you appear to be getting, it would appear as though you did not
successfully compile the monitors against RRD.
-- begin pingmon/main.c line 187 - 200
if (!strcasecmp(words[0], "RRDTOOL"))
{
if (words[1] && !strcasecmp(words[1], "on"))
{
#ifdef RRDTOOL
++dorrd;
if (debug > 1)
fprintf(stderr, "readconfig(): RRD enabled\n");
#else
fprintf(stderr, "%s: RRDtool not supported\n", prognm);
#endif
}
continue;
}
-- end
You need to go back and recompile, properly specifying your root
directory for RRDTool during the Configure.
Hope that helps...
Russell
> ------------
> [root at ns2 init.d]# ./ippingmon.init start
> Starting /usr/local/snips/bin/ippingmon ...done
> 8613 pts/0 S 0:00 /usr/local/snips/bin/ippingmon
>
> [root at ns2 init.d]# ./ippingmon.init status
> ippingmon is running, pid 8613
> 8613 pts/0 S 0:00 /usr/local/snips/bin/ippingmon
> Process run file (/usr/local/snips/run/ippingmon.error) is:
>
> Date Mon Jun 7 15:41:23 IST 2004
> ippingmon- Reading global config file /usr/local/snips/etc/snips.conf
> (ippingmon).. locked pid-file, started new process (pid=8613)
> ippingmon: RRDtool not supported
> ------------
>
> In ippingmon-confg under /usr/local/snips/etc directory I've configured RRDTOOL ON , but still it gives the same error. What could be reason , do I require to start RRD from somewhere . I'm having very limited understating of RRD .
>
> Kindly guide.
>
> Thx & Reg
> Vikrant
--
Russell M. Van Tassell
russell at loosenut com
Don't ever slam the door; you might want to go back. - Don Herold
|